Order #: N9915BU-209
Mfg #: N9915BU-209
- Scalar measurement of long-lossy cables
- Scalar measurement of converters using frequency-offset
- Measurements: gain/loss (B/R), input power (R), output power (B)
- Requires two FieldFox units, each configured with the ERTA (Option 209), and accessories
- ERTA system maximum frequency is limited by each analyzer's frequency range (4 GHz for a pair of N9913Bs)
- Typical gain/loss (B/R) measurement uncertainty: ± 0.6 dB (f ≤ 4 GHz, frequency references locked to GPS)
- Typical dynamic range: 83 dB (f ≤ 4 GHz, frequency references locked to GPS)
- Typical maximum measurable attenuation: 108 dB (f ≤ 4 GHz, frequency references locked to GPS)
ERTA can be used to measure the scalar transmission gain or loss of an RF system. It is useful when measuring long lossy cables where the two ends cannot easily be brought together, such as those bolted in on ships or aircrafts. It is also useful in measuring the insertion loss of waveguide systems, or using the frequency-offset feature, devices such as mixers and converters.
ERTA measurements are based on two FieldFox units; one at each end of the measured DUT. One FieldFox is the source and reference receiver (R), while the other is the measurement receiver (B). The two FieldFox units are synchronized using hardware triggering. By taking advantage of FieldFox's InstAlign technique, ERTA can be used to make accurate gain or loss measurements.
Pre-requisite options: 210 (VNA transmission/reflection) and 233 (spectrum analyzer). Recommended options: 235 (preamplifier) and 307 (GPS receiver). An ERTA measurement system requires two FieldFox units and various accessories. See the FieldFox Configuration Guide for detailed ordering information.